Installing the Cisco Microsoft Windows Vista and Windows 7 USB Driver Installing the Cisco Microsoft Windows 2000 USB Driver
![cisco usb console driver 64 bit cisco usb console driver 64 bit](http://www.usconverters.com/images/large/xs8801/usb-rs232-adapter-LRG.jpg)
Installing the Cisco Microsoft Windows XP USB Driver Installing the Cisco Microsoft Windows USB Device DriverĪ USB device driver must be installed the first time a Microsoft Windows-based PC is connected to the USB console port on the switch. Mini-B (5-pin-connector) USB console port. Connect the other end of the cable to the switch Installing the Cisco Microsoft Windows USB Device Driver.Ĭable to the PC USB port.
#Cisco usb console driver 64 bit install
Switch USB console port to a Windows-based PC for the first time, install the DETAILED STEPSĮntering the Initial Configuration Information. PressĮntering the Initial Configuration Information. Terminal displays the bootloader sequence. Switch as described in the switch getting started guide. PC application such as HyperTerminal or ProcommPlus, makes communicationīetween the switch and your PC or terminal possible.īaud rate and character format of the PC or terminal to match the console port Terminal-emulation program on the PC or the terminal.
#Cisco usb console driver 64 bit serial
Uninstalling the Cisco Microsoft Windows USB DriverĬonnecting the RJ-45 Console Port SUMMARY STEPSĪdapter cable to the 9-pin serial port on the PC.Installing the Cisco Microsoft Windows USB Device Driver.YouĬan initially configure the entire stack from any member switch. Switches, connect to the console port of one of the switches in the stack.
![cisco usb console driver 64 bit cisco usb console driver 64 bit](https://www.usb-drivers.org/wp-content/uploads/2014/12/a2.png)
You lose the Telnet connection after entering theĪccessing the CLI Through the Console PortĬonfigured or unconfigured switch by connecting the RJ-45 console port or USBĬonsole port of the switch to your PC or workstation and accessing the switch Enter the information described inĬonfiguration information for the switch, save it to flash memory by using theĪddress 10.0.0.1 remains active on the switch until you enter theĬommand. Setup mode, open a Telnet session to the switch by entering the IP addressĮXEC command. Follow the stepsĭescribed in the getting started guide for turning on the switch and using Set the switch in Express Setup mode and connect a switchĮthernet port to an Ethernet port on your PC or workstation.